SUB-ZEROBUILT°IN USE& CARE
CLEANIHG
S°IAINLESS STEEL EX°IERIOR
Classic and platinum stainless steel
finishes: To clean the exterior of the classic
and platinum stainless steel finishes, use a
soft, nonabrasive stainless steel cleaner like
Signature Polish and apply with a soft 100%
lint-free cloth.
Signature Polish is available from Signature
Limited Laboratory, R O. Box 13436, Dayton,
Ohio 45413-0436, or 877-376-5474 (toil freeL
Carbon stainless steel finish: Carbon
stainless steel can be cleaned with mild soap
and water.
The carbon stainless steel finish uses the
interest of brushed steel to bring out the
maximum metallic luster of its charcoal back-
ground.
Different light types and source locations can
result in variations in shading on different
components and areas of large appliances.
These variations are normal with the carbon
finish and add to the unique character of
colored stainless steel
To bring out the natural luster of all three
finishes, lightly wipe the surface with a water-
dampened microfiber cloth followed by a dry
polishing chamois. All work should follow the
grain direction of the finish. Better results are
obtained by keeping the cloth in continuous
contact with the stainless steel
IN'I ERIOR CLEAqING
To clean interior surfaces and removable parts,
wash with a mild solution of soap and luke-
warm water with a little baking soda. Do not
use vinegar. Rinse and dry thoroughly. Avoid
getting water on lights, Control Center and
display panel.
GLASSWELL CLEAqING
To clean the glasswell of Models 685 and 695,
use a mild solution of soap and water with a
little baking soda. Wipe up spills after
removing the dispenser water grille.
For the stainless steel areas of the glasswell on
Models 685 and 695, you may use the Stain-
less Steel Exterior cleaning procedure.
SIGNATURE
POLISH
is ava lable f_o_
Labo_atoil'y=
R O, Box 13436=
Dayto_ 0_i0
45413-043f, oF
c_dl 8773755474
(toll f_>=e),
finist_eS}
2I
To Next Page
Loading...
Need help?
General
