8. Water SV
9. Alarm
10. Pumpdwn SV1
11. Pumpdwn SV2
12. Pumpdwn SV3
KEYPAD
START
Press and hold this key for 4 seconds to bring the controller in an operative status from
the stand-by status in which it normally is after being powered on except if H2 parameter
is set to AUTOSTART mode.
STOP
Press and hold this key for 4 seconds to stop the system and operate in Stand By mode.
MUTE
Press this key for 1 second, to disable the buzzer and alarm relay.
RESET
Press and hold this key for 4 seconds to reset HP,LPand antifreeze alarms which have
been set for MANUAL RESET incase P4 parameter is set to MANUALRESET mode.
TEMP
Press and hold this key for 1 seconds to display temperatures for all probes. Use up/down
key to scroll through the various probes attached. To exit this mode, press the temp key.
PRG, SEL, UP & DWN
Used to enter programming mode.
REGULATION OF CHILLER TEMPERATURE
The regulation of the Brine temperature is based on the CONTROL probe.
To Next Page
Loading...
