Troubleshooting
Troubleshooting
Microwave Drop-down Door Series
Microwave Drop-down Door Series
4-9
#826151 - Revision A - March, 2016
The microwave should be fully assembled.1
The microwave must be plugged in for at least two minutes before sensor2
cooking.
Room temperature can not exceed 95° F.3
The microwave can not be installed in any area where heat and/or steam is4
generated.
The microwave must be installed to allow proper ventilation. The exhaust5
vents on the front of the microwave can not be blocked.
Make sure the exterior of the cooking container and interior of the6
microwave are dry.
The sensor works with food at normal storage temperatures. For example7
chicken should be at refrigerator temperatures and can soup at room tem-
perature.
Avoid using aerosol sprays or cleaning solvents near the oven while using8
sensor settings. The sensor detects the vapor given off by the spray and
turns off before food is properly cooked.
If the sensor does not detect the vapor of the food, ERROR will appear and9
the oven will shut off.
The microwave should be fully assembled.1
The microwave must be plugged in for at least two minutes before sen-2
sor cooking.
Fill about 200 ml (7 oz, or .85 cups) of water into a 1000 ml (34 oz, or 43
cup) measuring cup.
Place the container in the center of the turntable and close the door.4
Touch TIMER/CLOCK pad once, the POWER LEVEL pad twice, the5
START pad once, the 1 pad once, and the 4 pad once. The microwave
is in the sensor cooking condition, and AH20 and ON appear in the dis-
play.
The microwave operates for the first 16 seconds without generating6
microwave energy. ERROR appears if the door is opened or
STOP/CLEAR is touched during the first stage of sensor cooking.
After about 16 seconds, microwave energy is produced.7
If ERROR is displayed or the oven does not turn off replace the AH8
Sensor or check the control unit.
If the microwave stops after 5 minutes and no ERROR code is dis-9
played, then the AH Sensor is normal.
AH SENSOR TESTS
WATER LOAD COOKING
TEST FOR AH SENSOR
TEST
PROCEDURE
COMPONENT TEST
To Next Page
Loading...