PHONE OPERATION (HANDS-FREE SYSTEM FOR CELLULAR PHONES)
130
3. Check that the message is displayed.
No. Function
(Mark Read) to mark mail unread or read on the
message inbox screen.
This function is available when “Update Message Read
Status on Phone (Update Message Read Status on
Phone)” is set to on. (→P.142)
Select to reply the message. (→P.130)
Select to display the previous or next message.
Select to have messages read out.
To cancel this function, select
(Stop).
When “Automatic Message Readout (Automatic
Message Readout)” is set to on, messages will be
automatically read out. (→P.142)
Select to make a call to the sender.
*: E-mail only
l Depending on the type of Bluetooth phone being connected, it
may be necessary to perform additional steps on the phone.
l Messages are displayed in the appropriate connected Bluetooth
phone’s registered mail address folder. Select the tab of the
desired folder to be displayed.
l Only received messages on the connected Bluetooth phone can
be displayed.
l The text of the message is not displayed while driving.
l Turn the “POWER/VOLUME” knob, or use the volume control
switch on the steering wheel to adjust the message readout
volume.
REPLYING TO A MESSAGE (QUICK REPLY)
15 messages have already been stored.
1. Display the message inbox screen. (→P.127)
2. Select the desired message from the list.
3. Select
(Quick Message).
docstructure.indb 130 2016/03/30 11:16:02
To Next Page