Subaru EX40 - (13) MAIN BEARING COVER

- 34 -
(13) MAIN BEARING COVER
Apply oil to the bearing and the oil seal lip when mounting the main bearing cover. Also apply sealant
(Three Bond “1215”) to the surface of the crankcase. To avoid damaging the oil seal lip, wrap the
crankshaft key-way portion with polyvinyl tape before mounting the main bearing cover.
NOTE: Be careful that the lever portion of governor shaft does not face the main bearing cover.
Fig.5-48
MAIN BEARING COVER
GOVERNOR SHAFT
M8 x 38 mm : 8 pcs.
(12mm box wrench)
SEALANT
(
Three bond1215
)
㧮
VIEW B
Tightening torque
22.0 - 24.0 N
・
m
(220 - 240 kgf
・
cm )
(16.2 - 17.7 ft
・
lb.)