Subaru F541SFL000 User Manual

PART NUMBER ISSUE DATE PAGE
SUBARU
1/301/13/202001
INSTALLATION
INSTRUCTIONS
PART NUMBER:
DESCRIPTION: MOONROOF AIR DEFLECTOR
Phillips head screwdriver
Tools Required
SGD32
A B C
D
E F G
x2x2x1
2x 2x1x
F541SFL000
•
DO NOT USE SOLVENT BASED CLEANERS ON MOONROOF AIR DEFLECTOR.
DO NOT USE LOCTITE ON DEFLECTOR ATTACHING SCREWS.
•
USE SOAP AND WATER ONLY TO CLEAN MOONROOF AIR DEFLECTOR.
•
IMPORTANT NOTES
F541SFL000
The moonroof air deflector is designed to reduce wind noise when the moonroof is in the opened position.
However, in some cases wind noise may be slightly louder with the moonroof in the tilt or closed position.
VEHICLE DESCRIPTION: SUBARU CROSSTREK
T
:Install
:Disconnect
:Connect
:Location of Clips or Screws
:Remove
:Loosen
:Discard
:Re - use
:Tightening Torque
Meaning of Characters:
10
NO POWER TOOLS
2x

Subaru F541SFL000 Specifications

General

Brand	Subaru
Model	F541SFL000
Category	Automobile Accessories
Language	English

Summary

Installation Overview and Components

Parts Identification

Lists all components (A-G) required for installation, including the deflector, screws, clips, and cleaning wipes.

Tools and Symbols Guide

Details necessary tools for installation and explains the meaning of various symbols used in the instructions.

Important Installation Notes

Provides critical warnings and guidelines, such as avoiding solvent cleaners and loctite.

Installation Procedure

Preparation and Initial Steps

Covers initial steps like reading instructions, cleaning the roof, opening the moonroof, and preparing components.

Deflector Assembly and Positioning

Details securing clips to the deflector and centering it on the roof within specified measurements.

Marking and Adhesive Application

Explains how to mark bracket locations and apply adhesive tape to the cleaned roof surface.

Final Attachment and Tightening

Guides on attaching the deflector, ensuring proper seal placement, and tightening screws securely.

Post-Installation Checks

Includes checks for seal flatness and deflector height, with a warning against exceeding 30mm above moon roof glass.