IMPREZA(NA) A1830BE-A (ENGLISH)
Instruments and controls
3-14
Always make sure this light is out before you start to
drive.
J Front-wheel drive warning light
(for AT vehicles – if equipped)
This light comes on when All Wheel Drive is disen-
gaged and the drive mechanism is switched to Front
Wheel Drive for maintenance or similar purposes.
J Shift position indicator (AT vehicles)
This indicator shows the position of the shift lever.
J Turn signal indicator lights
These lights show the operation of the turn signal or
lane change signal.
If the indicator lights do not blink or blink rapidly, the
turn signal bulb may be burned out. Replace the
bulb as soon as possible. Refer to the “Replacing
bulbs” section in chapter 11.
J High beam indicator light
This light shows that the headlights are in the high
beam mode.
This indicator light also comes on when operating
headlight flasher.
Clock
HG3009BB
1) “S” button
2) “H” button
3) “M” button
To set the hour, press the “H” button. To set the min-
utes, press the “M” button. To reset the minutes the
“00” with a radio time signal, push the “ S” button.
CAUTION
To ensure safety, do not attempt to set the
time during driving, as an accident from inad-
equate steering operation could result.
To Next Page
Loading...
