IMPREZA(NA) A1830BE-A (ENGLISH)
2
Keys and doors
2-15
– CONTINUED –
J Disarming the system
Briefly press the “UNLOCK/DISARM” button (for less
than two seconds) on the remote transmitter. The
driver’s door will unlock, the horn will sound two
times, the parking lights will flash two times and the
indicator light will go off.
To unlock all doors (and the rear gate on the
wagon), briefly press the “UNLOCK/DISARM” button
a second time.
B Emergency disarming
If you cannot disarm the system using the transmit-
ter (i.e. the transmitter is lost, broken or the transmit-
ter battery is too weak), you can disarm the system
without using the transmitter.
To disarm the system:
1. Unlock the door with the key and then open the
door.
2. The alarm will sound.
3. Insert the key into the ignition switch and cycle it
from the “LOCK” to the “ON” position three (3) times
within 5 seconds.
J Sounding a panic alarm
To activate the alarm, keep the “LOCK/ARM” button
pressed for more than two seconds.
To deactivate it, press the “LOCK/ARM” button or
“UNLOCK/DISARM” button.
The parking lights will also flash when the alarm is
activated.
Unless a button on the remote is pressed, the alarm
will be deactivated after approximately 30 seconds.
J Valet mode
When you choose the valet mode, the security sys-
tem does not operate. In valet mode, the remote
transmitter is used only for locking and unlocking
the doors (and rear gate on the wagon) and panic
activation.
To enter the valet mode, open the driver’s door and
keep the “UNLOCK/DISARM” button depressed for
more than two seconds. The indicator light repeat-
edly flashes two times while the system is in valet
mode.
To exit valet mode, open the driver’s door and keep
the “ UNLOCK/DISARM” button pressed for more
than two seconds. The indicator will stop flashing.
J Passive arming
When passive arming mode has been programmed
by the dealer, arming of the system is automatically
accomplished without using the remote transmitter.
To Next Page
Loading...
