IMPREZA(NA) A1830BE-A (ENGLISH)
9
In case of emergency
9-17
– CONTINUED –
1. Take out the towing eye, screwdriver and wheel
nut wrench from the on board tool bag.
2. Pry off the cover on the front bumper using a
screwdriver, and you will find a threaded hole for at-
taching the towing eye.
3. Screw the towing eye into the threaded hole until
its thread can no longer be seen.
4. Tighten the towing eye securely with a wheel nut
wrench.
After towing, remove the towing eye from the vehicle
and stow it in the tool bag. Put the threaded hole
cover on the front bumper.
WARNING
D Do not use the towing eye except when tow-
ing your vehicle.
D Be sure to remove the towing eye after tow-
ing. Leaving the towing eye mounted on the
vehicle could interfere with proper operation
of the SRS airbag system in a frontal collision.
Rear towing eye:
HG9004CA
CAUTION
Do not apply excessive lateral load to the tow-
ing eyes.
To Next Page
Loading...
