Suburban SCS3BE User Manual

TROUBLE SHOOTING GUIDE FOR SUBURBAN RANGES
- RANGE ASSEMBLY -
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
 A. Hinge spring too loose (sprung) A. Replace door hinge assemblies
B. Hinge foot not properly installed into oven front
frame
B. Inspect hinge foot connection to oven frame,
adjust as required by lifting door from bottom and
gently pulling door forward to allow notch in hinge
foot to catch on the bottom of the slot on the front
frame

A. Latch is improperly adjusted
A. Inspect and adjust top latch accordingly
B. Range installed incorrectly, underside of top hits
counter top before latch catches
B. Correct installation so that range top rests evenly
on burner box and counter top with latch caught on
control panel
- SLIDE-IN AND DROP-IN COOK TOP -
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
BURNER WON’T LIGHT A. Clogged burner port(s)
A. Clean ports with a small wire or pin. Be sure
not to enlarge ports. Never use a wire brush which
may “shed” bristles which may become lodged in the
orice or burner ports and cause a re or explosion
B. Insufcient gas pressure
B. Inspect propane supply, inspect for gas leaks,
have propane pressure inspected by a qualied
service technician
BURNER WON’T LIGHT WIHT PIEZO

A. Improper installation
A. Inspect Piezo wire connections at electrodes and
Piezo for proper installation
B. Defective electrode in burner
B. Inspect electrode for spark. Replace burner if
defective
C. Defective Piezo C. Inspect Piezo. Replace if defective
BURNER FLAME IS UNEVEN OR TOO SMALL A. Clogged burner port
A. Clean ports with a small wire or pin. Be sure not
to enlarge ports
B. Insufcient gas pressure
B. Inspect propane supply, inspect for gas leaks,
have propane pressure inspected by a qualied
service technician (11” W.C. - 14” W.C.)
FLAME LIFTS OFF BURNER A. Propane pressure too high
A. Inspect propane supply, inspect for gas leaks,
have propane pressure inspected by a qualied
service technician (11” W.C. - 14” W.C.)

A. Burner tube to orice holder alignment incorrect
(sealed burner models only)
A. Inspect orice holder mounting bracket for proper
positioning in relation to the burner tube
13

Suburban SCS3BE Specifications

General

Brand	Suburban
Model	SCS3BE
Category	Ranges
Language	English