Need help?Do you have a question about the Suhr BELLA and is the answer not in the manual?
Controls the main power ON/OFF state of the amplifier.
Manages standby mode and selects between 22W and 44W output.
Primary connection point for a guitar or instrument.
2-position switch to increase input gain stage for a boost effect.
3-position switch to tailor high-frequency response and tonal character.
Adjusts output and preamp gain, influencing breakup characteristics.
Controls high frequencies for clarity, definition, or a warm tone.
Adjusts low frequencies for body, fullness, or a tighter bottom-end.
Modifies upper mid frequencies for increased definition or warmth.
Details power connection, including inlet and fuse specifications for safety.
Covers impedance selection and external speaker outputs for versatility.
Explains send/return jacks and levels for integrating external effects pedals.
Jack for an external footswitch to control the boost feature remotely.
Power| output | 22/44 Watts |
|---|---|
| mains fuse | T2A/250V (Slo-Blo) - 100/120VAC |
| h.t. fuse | F.5A/250V (Fast-Blo) |
Tubes| power section tubes | 2x6L6GC |
|---|---|
| pre-amp tubes | 3x12AX7 |
| effects loop and phase inverter tubes | 3x12AX7 |
Weight and Dimensions| weight | 50.8 lbs. |
|---|---|
| width | 24” |
| depth | 9.90” |
| height | 19.50” |
To Next Page
