SECTION 3 1800-3000 USER MANUAL
39
3.10 PIPING AND INSTRUMENTATION, 1800-2200 W/INTEGRAL DRYER
KEY
NO.
PART NO.
Q
T
Y
DESCRIPTION
N
O
T
E
1 02250125-369 1 FILTER, AIR 8”(PLASTIC) W/MTG BAND
2 - 1 VALVE, GROUP INLET DXX102E
3 MTR_VAR 1 MOTOR
4 - 1 COMPRESSOR
5 02250155-599 1 TANK, SEP 2200
6 02250160-773 1 ELEM,OIL SEP 1800/2200
7 02250097-609 1 VALVE, 1-5/8 SAE MIN PRESS CHK
8 02250156-137 1 COOLER, AIR/OIL 2200
9 02250167-115 1 SEP,WTR SCWS-235N 1” L/AD
10 02250155-708 1 FLTR,CORELESS M27 6”L W/BYPASS
11 02250148-796 1 VLV,THERMAL 210 DEG.
11 02250092-081 1 VLV,THERMAL 195 DEG.
12 02250155-174 2 XDCR,PRESS 0-250PSI 1-5VDC N4
13 250006-938 1 VALVE, RELIEF 1/2” 200#
14 02250155-175 1 PROBE,THERMISTER 3000 OHM NTC 6’L
15 02250049-634 1 VLV,BLWDN 1/4 NPT HI PRS
16 241771 1 STRAINER, V TYPE 1/4”
17 02250155-714 2 VALVE,SOL 3WNO 1/4 235# N4
18 250017-280 1 VALVE, PRESSURE REGULATOR
19 408893 1 VALVE, SHUTTLE 1/4” (DBL CHK)
20 250003-869 1 INDICATOR, RESTRICTION 20”H20
21 02250115-272 1 VLV,CHK 1/4”-NPT
22 02250170-783 1 VLV,DR COMBO 24 VDC
23 02250097-610 1 PLUG,SIGHT GLASS 1 5/16” SAE
24 02250126-129 1 GLASS,SIGHT SIGHT/ORIFICE BLK SAE
25 02250117-782 1 FILTER,ASSY GENESIS
26 02250125-774 1 ORIFICE,PLUG BRASS 1/8NPT X 1/32”
27 02250118-586 1 ORF, .078” .25FNPT X.25MNPT
28 02250078-249 1 SW,VAC 22”WC N4 6FT CABLE 5A
29 02250050-154 1 SW,DIFF PRESS 20 PSID
PLEASE NOTE: WHEN ORDERING PARTS,
INDICATE SERIAL NUMBER OF COMPRESSOR
30 02250168-837 1 VENT,ENCL PROT 1/2” TOP
31 02250169-612 1 GA,DIFF PRESS Z-PRG ASY BTM
32 - 1 INTEGRAL REFRIGERANT DRYER
33 049905 2 CHECK VALVE
34 02250175-087 1 PROBE,THERMISTER 3000 OHM NTC
12’L
35 02250173-972 1 FLTR,PNEUMATIC 1/8”NPT 5MICRON
1. PART NUMBERS ARE FOR REFERENCE ONLY. REFER TO BILL OF
MATERIAL AND OR FACE OF ORDER FOR ACTUAL PARTS.
2. SECTION BETWEEN LETTERED POINTS ARE TO BE REPLACED
WITH CORRESPONDING OPTION PICTURED BELOW, AS
REQUIRED BY FACE OF ORDER.
3, CONTROL/MOISTURE DRAIN LINES ARE 1/4" TUBING EXCEPT AS
NOTED.
4. OPTIONAL HEAT TRACE IS APPLIED ONLY TO CONTROL AND
MOISTURE DRAIN LINES AND USED ONLY WITH STAINLESS
STEEL TUBING. REFER TO FACE OF ORDER FOR HEAT TRACE
REQUIREMENTS.
5. PART VARIES BY MODEL.
COMPONENT DESCRIPTION
P1 WET SUMP PRESSURE
P2 LINE PRESSURE
DPSW1 FLUID FILTER DIFERENTIAL SWITCH
PSW1 INLET AIR FILTER SWITCH 22" WC (558.9 mm WC)
SOL1 LOAD/UNLOAD SOLENOID VALVE
SOL4 MEC/SEQUENCING/FULL LOAD SOLENOID VALVE
SOL5 ELECTRIC DRAIN SOLENOID VALVE
T1 WET DISCHARGE TEMPERATURE
T3 DRYER DEWPOINT TEMPERATURE PROBE
KEY
NO.
PART NO.
Q
T
Y
DESCRIPTION
N
O
T
E
PLEASE NOTE: WHEN ORDERING PARTS,
INDICATE SERIAL NUMBER OF COMPRESSOR
To Next Page
Loading...
