Sullair 750H - Page 33

SECTION 2 600H, 700HH, 750, 750H, 750HH, 825, 900H, 1050 USER MANUAL
33
2.9 PIPING AND INSTRUMENTATION DIAGRAM—LP/HP SINGLE (100, 150, 175 PSI)
Key Qty Description
1 1 FILTER, AIR
2 1 GAUGE, AIR FILTER RESTRICTION
3 1 INLET VALVE
4 1 COMPRESSOR
5 1 VALVE, RELIEF
6 1 SWITCH, TEMPERATURE
7 1 SENSOR, TEMPERATURE
8 3 SENSOR, PRESSURE
9 3 VALVE, DRAIN
10 1 RECEIVER, AIR/OIL
11 1 GLASS, SIGHT OIL LEVEL
12 1 VALVE, MINIMUM PRESSURE
13 2 VALVE, BALL
14 1 COOLER, AIR
15 1 SEPARATOR, MOISTURE
16 1 TRAP, DRAIN
17 4 ORIFICE
18 1 VALVE, RUNNING BLOWDOWN N.C.
19 1 SIGHTGLASS, ORIFICE BLOCK
20 1 VALVE, THERMAL BYPASS
21 1 COOLER, OIL
22 1 FILTER, OIL
23 1 VALVE, RECIRCULATION N.C.
24 1 VALVE, CONTROL PRESSURE REGULATOR
25 1 GAUGE, PRESSURE
26 2 VALVE, CHECK
27 1 VALVE, SOLENOID 3-WAY RUN/START
28 1 SEPARATOR, ELEMENT
29 1 VAVLE, REDUCING PRESSURE REGULATOR
30 2 VALVE, PRESSURE DIFF. BYPASS
31 3 STRAINER
32 1 SEPARATOR, OIL
33 1 SEPARATOR, CONTROL MOISTURE
NOTES:
P1 DRY SIDE PRESSURE
P2 CONTROL PRESSURE
P3 WET SIDE PRESSURE
T1 COMPRESSOR DISCHARGE TEMPERATURE SENSOR
T3 RECEIVER TANK TEMPERATURE SWITCH (RTT)
Key Qty Description