DHL HEATLESS REGENERATIVE DRYER SECTION 1
6
The right to warranty repairs is subordinated to the
strict compliance with the installation, use and
maintenance instructions contained in this manual.
The warranty will be immediately voided in case of
even small changes or alterations to the dryer.
To request repairs during the warranty period, the
data reported on the identification plate must be
notified.
Table 1-1: Dryer Specifications
IT IS RECOMMENDED TO FILL OUT THIS SECTION AT INITIAL START UP OF THE DRYER.
Model No. ____________________________________ Desiccant/Tower: ____________ LBS ____________
Serial No. ____________________________________ Inlet/Outlet Size: ____________ NPT ____________
Inlet Design Conditions: _________________________ Cycle Time: ___________ Standard Short Cycle _______
Flow: ________________________SCFM@
Pressure: ___________ 100 ________PSIG
Maximum Operating Pressure: ________________ PSIG
Temperature: ________ 100 ________°F
Minimum Operating Pressure: ________________ PSIG
Outlet Dew Point: _________°F PDP @ Above Conditions Maximum Operating Temperature: _________________°F
Purge Flow: __________ PSIG/SCFM _____________ Minimum Operating Temperature: _________________°F
Power Supply: _________V_________PH_________HZ
Current Draw: _____________ AMP ________________
1. This pressure is 95% of MAWP
2. Operating at “OFF” design conditions may adversely affect Outlet Dew Point.
3. Operation of dryer below 35°F requires heat tracing of certain components upstream of dryer outlet.
To Next Page
Loading...
