Section 7
MAINTENANCE
30
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
**
**
**
**
**
**
**
Figure 7-4 Solenoid Valve (P/N 250025-516)
*Replacement Valve P/N 02250053-334
**Replacement Coil P/N 250031-431
circuit. Place an insulating washer at each end of
the non--molded coil.
VALVE DISASSEMBLY MAINTENANCE
W ARNING
!
Turn off all power , relieve line pressure, and dis-
connect coil lead wires to the valve before making
repairs.
1. Remove retaining clip and pull entire solenoid en-
closure off solenoid base sub--assembly.
CAUTION
!
When metal retaining clip disengages it will spring
upward.
2. Unscrew solenoid base sub--assembly and re-
move core spring guide and core spring.
3. Unscrew capscrews (4) and remove end cap and
end cap gasket from body.
4. Pull inner disc sub--assembly, disc spring, sleeve
and outer disc sub--assembly from valve body.
Remove sleeve spring, core and bonnet gasket.
5. If cleaning is all that is required, do not remove
body (exhaust) seat, body seat gasket, end cap
To Next Page
Loading...
