Sullair ES-6 10H - Page 35

Section 7
ILLUSTRATIONS AND PARTS LIST
29
7.3 FLUID MANAGEMENT SYSTEM
key part
number description number quantity
1 plug, hex head 1 1/16”--12 SAE 250039--359 1
2o--ring
(I)
250025--419 3
3 housing, bell 250025--309 1
4 o--ring, 1 7/16” x 1/16” 826502--127 1
5 element, separator air/fluid
(II)
250025--264 1
6 o--ring, 2 3/16” x 3/32” 826502--139 1
7 cap, separator element 250026--038 1
8 element, fluid filter
(III)
250026--982 1
9 adapter, fluid filter 250025--914 1
10 glass, sight 250025--420 1
11 plug, thermostat 1 1/16”--12 250025--418 1
12 guide, thermostat spring 250025--417 1
13 pin, roll 1/4” x 1 1/2” 827404--150 1
14 spring, compression 250025--464 1
15 piston, thermostat 250025--415 1
16 actuator, thermostat
(IV)
250025--413 1
17 capscrew, ferry hd 1/2”--13 x 3” 828408--300 12
S
capscrew, socket ISO4762 m 12 x 80 (metric) 829312--080 12
18 decal, fluid
(V)
-- 1
(I)
For replacement only.
(II)
For maintenance on air/fluid separator element no. 250025--264, order repair kit no. 250028--033.
(III)
For maintenance on fluid filter element no. 250026--982, order repair kit no. 250028--032.
(IV)
For maintenance on thermostat actuator no. 250025--413, order repair kit no. 250028--036.
(V)
Decal will vary with compressor fluid fill requirement. Factory fill (Sullube) decal part no. is 02250069--389.
PLEASE NOTE: WHEN ORDERING PARTS, INDICATE SERIAL NUMBER OF COMPRESSOR