Sullair ES-8-25H - 1.10 Entrapment Prevention

TABLE OF CONTENTS
(CONTINUED)
Section 5 PAGE
SUPERVISOR II 19 5.1 INTRODUCTION
19 5.2 KEYPAD
19 5.3 STATUS DISPLAYS
20 5.4 LAMP INDICATORS
Section 6
COMPRESSOR OPERATION-
SUPERVISOR II
21 6.1 INTRODUCTION
21 6.2 STANDARD PARAMETER SETUP
21 6.3 SEQUENCING PARAMETERS SETUP
22 6.4 OPERATING THE COMPRESSOR
23 6.5 PURPOSE OF CONTROLS
24 6.6 SUPERVISOR OUTPUT RELAYS
24 6.7 INITIAL START-UP PROCEDURE
24 6.8 SUBSEQUENT START-UP PROCEDURE
24 6.9 SHUTDOWN PROCEDURE
Section 7
COMPRESSOR OPERATION-
ELECTRO-MECHANICAL 25 7.1 INTRODUCTION
25 7.2 PURPOSE OF CONTROLS- ELECTRO-MECHANICAL
26 7.3 INITIAL START-UP PROCEDURE
26 7.4 SUBSEQUENT START-UP PROCEDURE
26 7.5 SHUTDOWN PROCEDURE
Section 8
MAINTENANCE 27 8.1 INTRODUCTION
27 8.2 DAILY OPERATION
27 8.3 MOTOR BEARING LUBRICATION
27 8.4 FLUID FILTER MAINTENANCE
27 8.5 COOLER MAINTENANCE
28 8.6 PARTS REPLACEMENT AND ADJ USTMENT PROCEDURES
28 RELIEF VALVE
28 FLUID FILTER REPLACEMENT
28 AIR FILTER MAINTENANCE- STANDARD MODEL
29 AIR FILTER MAINTENACE- BASIC MODEL
29 SEPARATOR ELEMENT REPLACEMENT
29 DRIVE COUPLING INSTALLATION
30 INLET CONTROL VALVE