Sullair OWS-88 - DESCRIPTION; OIL WATER SEPARATOR MODELS

Section 1
5
OIL WATER SEPARATOR
DESCRIPTION
Compressed air holds water and oil vapor. Once that
vapor cools into a liquid (condensate), it is a dirty, oily
watery mixture that should not be simply dumped
down the drain. The condensate is approximately
95% water and 5%. therefore a Sullair OWS has
been specially developed to reduce or eliminate the
amount of oil in the condensate and reducing or
eliminating disposal costs and related issues.
Type
Sullair
Part No.
Body Material
Max.
Working
Temp
Max.
Working
Pressure
Max.
Compressor
Capacity
Dimensions (mm)
Wt.
Connections
Kit
Width Depth Height
Condensate
-inlet
Water-
discharge
Oil-
discharge
OWS-88 02250193-619 Polyethylene 95ºF 0 88 11 8.3 21.7 7 3x1/2” 1” —
02250193-
641
OWS-210 02250193-620 Polyethylene 95ºF 0 210 17.2 12.8 35.8 18 4x1/2” 1” —
02250193-
642
OWS-420 02250193-621 Polyethylene 95ºF 0 420 24.4 20.5 38 25 4x1/2” 1” —
02250193-
643
OWS-880 02250193-622 Polyethylene 95ºF 0 880 24.4 20.5 45.7 40 4x1/2” 1” 1”
02250193-
644
OWS-1700 02250193-624 Polyethylene 95ºF 0 1700 33.5 20.5 45.7 60 4x1/2” 1” 1”
02250193-
645
OWS-2100 02250193-625 Polyethylene 95ºF 0 2100 33.5 20.5 45.7 65 4x1/2” 1” 1”
02250193-
646
Note:
ATF (Automatic Transmission Fluid) cannot be separated by the OWS oil/water separator
SCFM is at 102 psig and 95¡F inlet conditions with 65% relative humidity.
Capacity conditions can vary depending on compressor fluid used.