Sumitomo HF-320a Series - Page 105

F-4
6
6.1.3 Output of set frequency speed reach signal
 : Speed reach setting frequency
 : Speed reach detection band
• Function
When the output frequency becomes equal to the frequency set by ±, an ON or OFF
signal is generated.
■ Parameter setting of frequency and detection band
Title Function Adjustment range Default setting
 Speed reach setting frequency
0.0 ∼  (Hz)
0.0

Speed reach detection band
0.0 ∼  (Hz)
2.5
■ Parameter setting of output terminal selection
Title Function Adjustment range Default setting

Output terminal
selection 2A (DRV-OM)
0-255
(See Section 11, K-18)
8: RCHF (designated frequency - ON
signal), or 9: RCHFN (designated
frequency - OFF signal)
Note: Select the  parameter to specify RY-RC terminal output, or set the  parameter function
No. to 8 or 9 to specify FA-FC-FB terminal output.
If the detection band value + the set frequency is less than the designated frequency
Set frquency speed reach signal
RY-RO terminals
P24V-DRV terminals
FA-FC-FB terminals
Set frequency speed reach signal:
Inverted
Output frequency [Hz]
Time [s]

-

ON
OFF

+


ON
OFF
0