Sumitomo HF-320a Series - Page 152

F-51
6
[Selection 1: Setting by automatic torque boost]
This is the easiest of the available methods. It conducts vector control and auto-tuning at the same time.
Set the automatic torque boost  to 
(Automatic torque boost + auto-tuning)
Set the automatic torque boost  to 
(Sensorless vector control + auto-tuning).
Set the automatic torque boost  to 
(Energy-saving + auto-tuning)
See Section 5.2 for details of the setting method.
[Selection 2: Setting sensorless vector control and auto-tuning independently]
This method sets sensorless vector control or automatic torque boost, and auto-tuning independently.
Specify the control mode selection parameter () and then set auto-tuning.
Set the auto-tuning parameter  to 
(Auto-tuning enabled)
[Parameter setting]
Title Function Adjustment range Default setting
 Auto-tuning
0: Auto-tuning disabled (use of internal parameters)
1: Application of individual settings of  (after
execution: 0)
2: Auto-tuning enabled (after execution: 0)
0
Set  to .