3
Operation
LED On Flashing Off
LED Display
STOP Key
Stop the drive.
LED Display
REV
FOUT
DRV
ALM
ENTER Key
Select all modes, parameters,
settings, etc.
Select a menu item to move from
one display screen to the next.
Data Display Area
(5-digit)
Displays frequency, parameter
number, and other data.
LO/RE Lamp
Light to indicate that the
operator is set to LOCAL.
ESC Key
Return to the previous menu.
Easy Operation
Used as a quick guide for the
abbreviations used on the
display screen.
RESET & SHIFT Key
Resets to clear a fault situation.
Move the cursor to the right.
RUN Lamp
Light while the drive is operating
the motor.
RUN Key
Start the drive.
Communication Port
Port used for LED Operator.
Up Key
Scroll up to select parameter
numbers, setting values, etc.
Down Key
Scroll down to select parameter
numbers, setting values, etc.
LO/RE Selection Key
Switch drive control between the
operator (LOCAL) and
the control terminals (REMOTE).
When the inverter
detect the alarm
• When an alarm occurs
• OPE (Operation Error) detected
•
When a fault or error occurs during Auto-Tuning
• During deceleration to stop
• When the Run command is input and
the frequency reference is 0.
Motor is rotating in reverse
Drive Mode.
• Drive Mode
• Auto-Tuning
Display output frequency (Hz)
When the Run command is selected from
the LED operator (LOCAL).
During run
Normal state
Motor Forward rotation
Programming mode
Display except output frequency
Other than LED operator
(REMOTE)
During stop
To Next Page
Loading...
