To clear map ...
Select CH Clear map to automatically remove all channels from a map.
Press VOL to accept this selection.
Press CH to select the map to be cleared.
Press VOL . The channels are removed from the map after a short pause
and the word "empty" appears beside the selected map.
To Add/Delete channels
Select CH
Add/Delete channels to add/remove channels, one at a time.
Press VOL to accept this selection.
Press CH to select a map.
Press VOL . The message, Add/Delete channels with the map number
appears on the TV screen.
Press VOL + to add the channel to the selected map. When + appears
beside the channel number, it confirms that this channel has been added.
Press VOL- to remove the channel from the selected map. When - appears
beside the channel number, it confirms that this channel has been removed.
Fine tune - Select CH FineTune to adjust the TV signal. Hold down VOL+
to make the signal stronger or VOL- to make the signal weaker. The suggested
level of fine tuning is generally close to 0.
Video Mode -
Select CH Video Mode to change the source of the TV or Video, PC
Press VOL+ to accept this selection.
Whenever this VOL+ button is pressed.
20
Owner's Manual
To assign a channel map ...
Select CH Assign channel maps to program the channel selection with
the appropriate level of service.
Press VOL to accept this selection.
Press CH to select this level of service.
Press VOL to assign a map by number to the selected service level.
Continue to press VOL
until the desired map number has been assigned.
When an empty channel map is assigned to
an available service level, any attempt to
access this service level produces this
message.
When a service level is not used, assign it
an empty channel map.
To autoprogram channel maps ...
Select CH Autoprogram to quickly add several channels to a selected
map. Tune to the first channel that you wish to select in this process.
Channels are added or removed either by pressing CH
or by entering the
number of the desired channel, using the digit keys on the infrared hand unit.
Press VOL to accept the selection.
Press CH
to select the map. The word "empty" appears beside any map
to which channels are not assigned.
Press VOL . Autoprogram and the channel number appears on the TV
screen.
Press CH to begin adding channels. Channels, above the channel
number to which the TV is currently tuned, will be added, one by one.
To stop autoprogramming, press VOL .
If you choose not to automatically add any channels to the map, press VOL
and return to the previous menu.
19
Owner's Manual
How do I change the set up of the channels?
TV VIDEO PC
How do I change the set up of the channels?
No Channels
Available.
Please Contact TV
Representative.
To Next Page
Loading...