Sumitomo PARAMAX 9000 Series - Inspection Upon Delivery; How to Check the Nameplate

3
COMMON
1. Inspection upon delivery
Upon delivery of the PARAMAX DRIVE check the following:
There are two types of nameplates. Some typical plates are shown below; refer to the proper one.
(1) The descriptions on the ratng palte conform to your order.
(2) There were no parts damaged during transport.
(3) All bolts and nuts are firmly tightened
If there is any doubt that the unit delivered does not conform to the one ordered, contact the nearest agent, distributor, or
service office.
(1) DRIVE UNIT or REDUCER
(2) Motor
•
Unpack the unit after verifying that it is positioned right side up; otherwise, injury may result.
•
Verify that the unit received is exactly the ordered item. When a different product is installed, injury or damage to
the system may result.
•
Do not remove nameplate.
CAUTION
1-1) How to check the nameplate
!
• When making an inquiry, advise us of MODEL RATIO SERIAL NO.
Type of Drive unit or Reducer
(Refer to page 4.)
Reduction ratio
• Input power and speed
Serial number
Fig.1 Nameplate of Drive unit or Reducer
Fig.2 Nameplate of Motor
• Service factor
•
For motor with brake
Brake type
• Motor nomenclature
•
For motor with brake
Brake torque
Serial number
•
• Power factor
• IE code
• Motor eciency value
Brake current value
For motor with brake
• Motor capacity
• Motor characteristics
U
4
5
P
0
0
0
0
0
1
R
M O D E L
R A T I O
I N P U T
S E R I A L N O .
k W
ｒ / m i n
JAPAN