6
Explanation of Functions
Explanation of Functions
Common
Monitor
Output frequency monitor
Output current monitor
Operation direction monitor
PID feedback value monitor
Input terminal status monitor
Output terminal status monitor
Output frequency equivalent monitor
Tr i p m o ni t o r
Trip history monitor
• The output frequency and current value can also be monitored.
Input terminal status monitor
The status of all multifunctional input terminals is displayed together.
·Example of display
Output terminal status monitor
• The status of the error output terminal and multifunctional
output terminal is displayed together.
·Example of display
Output frequency equivalent monitor
• The output frequency multiplied by the conversion factor set
by is displayed.
Use this to display line speed. (Refer to p.10.)
Trip monitor
Trip history monitor
• displays the contents of the latest error. In addition
to the error code, the output frequency, output current, and
DC voltage between P and N at time of trip can be viewed.
• shows the error codes of the last two trips prior to
the latest one.(Refer to p.13)
Setting the output frequency
Output frequency setting
Setting the acceleration/deceleration time
Acceleration time 1 setting
Acceleration time 1 setting
· is the acceleration time from 0Hz to
(maximum frequency). is the deceleration time
from (maximum frequency) to 0Hz.
Setting the direction of operation
Operation direction setting
• The direction of motor operation (rotation) is set.
Setting the frequency command destination and
operation command destination
Frequency command
Operation command
•
The frequency command destination and operation/stop
command destination are set by the following codes.
Even if the operation command destination is set to the control
terminal, the key on the panel and operator is valid.
It can be made invalid as well. (Function code )
Setting the base frequency and maximum
frequency
Base frequency setting
Maximum frequency setting
• The base frequency and maximum frequency can be set
within the 50-360 Hz range (1 Hz).
Command
destination
01
02
Control terminal
(VRF and IRF
terminals)
Digital panel
Code
Code of operation
command destination
Terminal No. RST 3DF2DF RR FR
RST DFH DFM DFL RR FR
ON
OFF
(SF)
(HF)
Terminal No. AL DRV UPF
ON
OFF
(SF, HF)
The status of error output terminal ON means the case where an error
has occurred or power is turned off (b-contact point) or an error has
occurred (a-contact point).
• When setting the frequency command destination of
to 02:Panel or Digital operator, set the output frequency by
. Also use to set one of the multispeed
frequency.
Code of frequency
command destination
Command
destination
Code
Main unit
volume
00
Control terminal
(VRF and IRF
terminals)
01
Digital panel
02
To Next Page
Loading...
