After completion of assembly, turn the tank valve on and turn the control valves on the grill to the ‘HI/IGN’
position for 10 – 15 seconds to purge the line of air.
Inspect the hose before each use of the appliance. If it is evident there is excessive abrasion or wear, or the hose
is cut, it must be replaced prior to the appliance being put into operation. The replacement hose assembly shall be
that specified by the manufacturer.
To connect, insert the regulator inlet into the tank valve and turn the black coupler clockwise until the coupler
tightens up. DO NOT OVER TIGHTEN THE COUPLER.
To disconnect, turn the tank valve off. Hold the coupler sleeve and turn counter clockwise. The inlet line will be
disengaged.
If the appliance is not in use, the gas must be turned off at the supply cylinder. Cylinder must be stored outdoors
out of reach of children and must not be stored in a building, garage or any other enclosed area.
A dented, rusty or damaged propane cylinder must be replaced immediately.
Check for leaks every time the cylinder is replaced or reconnected. All leaks must be corrected
immediately.
*Never use an open flame to check for leaks.
(See illustration on p.13)
To Next Page
Loading...
