Front Panel Removal for All Models
Parts Removal and Replacement
Grill Burner: - Remove top grates.
- Remove briquettes and shields
- Remove clip at rear of burner and slide out.
- Clean and replace in reverse order.
Rotisserie Sparker: - Remove sparker cover – lift and pull.
- Remove sparker screws and pull out.
Trouble Shooting
Problem Solution
Burner will not light - Check gas supply to burner by manually lighting the burners.
- Check pilot side of valve for spark while gas is off
- Make sure spark area is clean from debris, webs etc.
- Make sure you now have a spark
- If no spark, check valve for defects
Improper burner flame - Check burner gas inlet area for any blockage and clear.
- Check orifice hoods for any clogging and clean.
- Check pressure if flame is too low or too high.
- Check gas supply tank (LP) if running low.
- Make sure that knobs are in off position when turning tank valve on!
To Next Page
Loading...
