Why does my Summit BIM44 G Ice Maker stop suddenly?
If your Summit Ice Maker suddenly stops, first check if there's a power outage and reconnect the power supply if needed. If the room temperature is outside the recommended range, disconnect the ice maker until the temperature is within range. Also, remove some ice cubes if the ice storage bin is full, and ensure the ice-full probe isn't blocked.
How to prevent scaling in my Summit Ice Maker?
If scaling occurs frequently inside your Summit Ice Maker, it indicates the water's hardness level is too high. Consider installing a water-softening device in front of the water inlet.
Why is my Summit Ice Maker not working?
First, ensure the Summit Ice Maker is plugged into a working outlet. If it still doesn't operate, check the fuse and replace it if blown. If the fuse blows again, it's recommended to call for service to inspect for a short circuit. Also, make sure that the power button is switched to the 'ON' position. Finally, if the ice storage bin is full, remove some ice, ensuring the ice-full probe is free from ice.
What to do if my Summit Ice Maker is leaking water?
If you notice water on the floor when opening the door to remove ice, this could be normal condensation. However, check the water supply connection to ensure it's tightened properly. Also, ensure the drain pipe is not higher than the drain outlet; if it is, lower the drain pipe.
Why is my Summit Ice Maker making ice but not filling the bin?
If your Summit Ice Maker makes ice, but the bin isn't filling, the condenser may be dirty and needs cleaning. Also, check the installation to ensure proper airflow to the ice maker. High ambient and water temperatures, or proximity to a heat source, can also affect ice production, so review the installation in such cases.
What to do if water doesn't feed into my Summit BIM44 G?
If water isn't feeding into your Summit Ice Maker after it starts, check that the water supply tap is turned on. Also, ensure the water supply pipe is correctly connected.
Why are the ice cubes from my Summit Ice Maker partially formed?
If the ice cubes from your Summit Ice Maker are partially formed or white at the bottom, it could indicate insufficient water in the water trough. Check if the water supply pressure is below 15 psig. Also, the water supply or filter may be restricted, or there might be a water leak at the water trough.
Why is water leaking from the ice storage bin of my Summit BIM44 G?
If water leaks from the ice storage bin of your Summit Ice Maker, the drainhole below the bin might be blocked; remove the bin and clean the drainhole. Also, check the drain hose to ensure it isn't kinked or positioned higher than the bin's floor, which would prevent proper drainage.
Why is my Summit BIM44 G Ice Maker making noise?
If your Summit Ice Maker is making noise, ensure the feet are leveled and locked properly. Also, some sounds during operation are normal.
What to do if the body of my Summit Ice Maker is electrified?
If the body of your Summit Ice Maker is electrified, the ground line might not be properly connected. Ensure you're using a socket that meets grounding requirements.
Lists basic safety precautions for fire, electric shock, and injury when using the ice maker.
Details the necessary electrical supply, grounding, and connection requirements for the ice maker.
Explains the step-by-step process of starting and operating the ice maker.
Details the process for cleaning the condenser to maintain efficient operation and prevent overheating.
Guide for cleaning the ice-making system to remove mineral deposits and maintain performance.
Provides a guide to identify and resolve common problems encountered with the ice maker.
General| Ice Storage Capacity | 25 lbs |
|---|---|
| Finish | Stainless Steel |
| Width | 14.5 inches |
| Defrost Type | Automatic |
| Ice Type | Cube |
| Refrigerant | R134a |
| Type | Ice Maker |
| Ice Production | 44 lbs |
| Height | 33.5 inches |
| Power Supply | 115V, 60Hz |
| Door Style | Solid |
To Next Page
