Why is my Summit BIM68OSPUMP Ice Maker not operating?
If your Summit Ice Maker isn't working, check these potential causes: * Make sure the ice maker is plugged in. * Check the breaker and reset it if tripped. If tripping continues, contact an authorized service center. * Ensure the switch is set to “ICE” and not “OFF”. * If the ice tank is full, the ice maker will stop. Wait 15-30 minutes after removing ice for it to resume operation.
What to do if my Summit BIM68OSPUMP Ice Maker is operating, but no ice is made?
If your Summit Ice Maker is running but not producing ice, there are several potential causes to investigate: * Ensure there's enough water in the tank and that the water supply valve is open. * If ice cubes are stuck on the vaporizer, check the water supply and hot gas valve. * If the water isn't getting cold, inspect the water supply valve; if it's working, contact customer service. * Verify water is being sprayed and that the circulation pump is functioning. * Examine the condenser for dust and clean it, and also check the condenser fan motor. * Confirm that the ambient temperature isn't too high. * For hot gas leaks or if refrigerant needs refilling, contact customer service.
What to do if my Summit BIM68OSPUMP Ice Maker tank is not fully filled with ice cubes?
If the ice tank in your Summit Ice Maker isn't filling completely, consider these factors: * The ice tank will be filled with ice after about 12 hours of operation. * Ensure the drain pipe of the water tank is properly connected and clean the drain. * Check the installation site to ensure hot air isn't blowing into the tank.
Why are the ice cubes from my Summit Ice Maker too small?
If the ice cubes from your Summit Ice Maker are too small, here are a few things to check: * The ambient temperature may be too high; lower ambient temperatures result in larger ice cubes. * Ensure there's enough water in the water tank by checking the water supply. * Make sure the water nozzle isn't clogged, preventing water from ejecting properly. * For issues with ice thickness control, contact customer service.
Why are the ice cubes from my Summit BIM68OSPUMP too large?
If the ice cubes from your Summit Ice Maker are too large, consider these factors: * The ambient temperature might be too low; lower temperatures produce larger ice. * If you're having trouble controlling the ice thickness, contact customer service.
Why is the ice fragmented in my Summit BIM68OSPUMP?
If the ice from your Summit Ice Maker is fragmented, the water may not be spraying accurately from the nozzle to the center of the vaporizer cube. Clean the ice maker, as the nozzle may be clogged.
Why are the ice cubes from my Summit Ice Maker white?
If the ice cubes from your Summit Ice Maker appear white, it could be due to too little water in the water tank. Check the water supply and inspect the tank for any leaks.
Explains safety alert symbols, DANGER, WARNING, and CAUTION definitions for hazard awareness.
Covers grounding, plug usage, and avoids adapters/extension cords to prevent shock.
Mandates proper positioning, supervised operation, and correct servicing procedures.
Stresses the necessity of proper grounding for electrical safety via a 3-prong outlet.
Guides on the first-time operation and regular usage of the ice maker.
Provides solutions for typical issues encountered during the ice maker's operation.
General| Type | Undercounter |
|---|---|
| Defrost Type | Automatic |
| Daily Ice Production | 68 lbs |
| Door Swing | Reversible |
| Built-In Capable | Yes |
| Finish | Stainless Steel |
To Next Page
