What to do if Summit SFC-500 shows a Common Trouble?
If your Summit Control Panel indicates a Common Trouble, you should: * Check for any missing interconnection wiring. * Check for any module missing that was part of the configuration. * Check for improperly secured cabling.
What to do if Summit Control Panel indicates Battery Trouble?
If your Summit Control Panel is showing a Battery Trouble due to low voltage (below 20.4V), replace the batteries as soon as possible.
What to do if Summit Control Panel indicates a Ground Fault?
If your Summit Control Panel indicates a Ground Fault, check for any external wiring touching the chassis or other Earth Ground connection.
How to fix Circuit Trouble on a Summit SFC-500?
To resolve Circuit Trouble on your Summit Control Panel, check for open wiring on that particular circuit loop or ensure that the Circuit Disconnect Switch is in the ON or CLOSED position.
Instructions for mounting the SFC-500 Fire Alarm Panel enclosure.
Details on connecting cables and jumpers on the main fire alarm board for modules.
Details on the SOCA-204 module for converting indicating circuits to Class A.
Information on installing the SPR-200 module for polarity reversal and city tie functions.
Overview of addressable and analog devices, including loop interface and device currents.
Wiring guidelines for addressable loops and main board connections.
Information on connecting the main AC power supply to the panel.
Common system symptoms and their possible causes and solutions.
Critical warnings for users/installers and potential causes of system failure.
Details on warranty coverage, service procedures, and disclaimers.
General| Brand | Summit |
|---|---|
| Model | SFC-500 SERIES |
| Category | Control Panel |
| Language | English |
To Next Page