setroute(8)
System Administration 239
â– To reflect the routing information to XSCF, execute the applynetwork(8)
command. After reflected the information, use the rebootxscf(8) command to
reset XSCF to complete the setting.
â– The showroute(8) command can display the current routing information that is
set for the XSCF network.
EXAMPLES
EXAMPLE 1 Adds the routing of destination 192.168.1.0 and netmask 255.255.255.0 for
XSCF-LAN#0 on XSCF unit 0.
EXAMPLE 2 Adds the routing of destination 192.168.1.0 and gateway 192.168.1.1 for
XSCF-LAN#1 on XSCF unit 0.
EXAMPLE 3 Adds the routing of destination 192.168.1.0 and default netmask
(255.255.255.0) for XSCF-LAN#1 on XSCF unit 0.
EXAMPLE 4 Deletes the routing of destination 192.168.1.0 and default netmask
(255.255.255.0) from XSCF-LAN#1 on XSCF unit 0.
EXAMPLE 5 Adds the routing of destination 192.168.1. 4 for XSCF-LAN#1 on XSCF unit 0.
EXAMPLE 6 Deletes the routing of destination 192.168.1. 4 from XSCF-LAN#1 on XSCF
unit 0.
EXAMPLE 7 Adds routing information for the default gateway 192.168.10.1 for XSCF-
LAN#1 on XSCF unit 0.
XSCF> setroute -c add -n 192.168.1.0 -m 255.255.255.0 xscf#0-lan#0
XSCF> setroute -c add -n 192.168.1.0 -g 192.168.1.1 xscf#0-lan#1
XSCF> setroute -c add -n 192.168.1.0 xscf#0-lan#1
XSCF> setroute -c del -n 192.168.1.0 -m 255.255.255.0 xscf#0-lan#1
XSCF> setroute -c add -n 192.168.1.4 xscf#0-lan#1
XSCF> setroute -c del -n 192.168.1.4 xscf#0-lan#1
XSCF> setroute -c add -n 0.0.0.0 -g 192.168.10.1 xscf#0-lan#1
To Next Page
Loading...
Need help?
General
