showdcl(8)
System Administration 327
If the -v option is specified, the following information is added:
Privileges You must have one of the following privileges to run this command:
Refer to setprivileges(8) for more information.
Cfg-policy Degradation range applicable for an error detected during an
initial diagnosis of hardware. Any of the following is displayed:
FRU Degradation of a component (default)
XSB Degradation of an XSB.
System Degradation of a domain
No-Mem Whether to omit the use of memory on a domain. Either of the
following is displayed:
True Omits the use of memory on a domain.
False Does not omits the use of memory on a
domain (default).
No-IO Whether to omit the use of I/O devices on a domain. Either of
the following is displayed:
True Omits the use of I/O devices on a domain.
False Does not omit the use of I/O devices on a
domain (default).
Float Whether to set a priority for the specified LSB as a floating board,
relative to other boards. Either of the following is displayed:
True Gives a higher priority to the LSB to become
a floating board.
False Does not give a higher priority regarding
floating boards (default).
platadm, platop, fieldeng
Can execute the command for all domains.
domainadm, domainmgr, domainop
Can execute the command only for accessible domain.
To Next Page
Loading...
Need help?
General
