Sun2Solar 902534 - Safety Instructions; General Information; Product Care; Tools and Accessories Required

Safety Instrucons
Read through these instrucons carefully before you use
the product.
CAUTION: Failure to comply fully without instrucons for
use, or safety instrucons, may cause damage to the unit or
injury to individuals.
• Please read the instrucon manual and the
direcons shown
• Do not allow children to handle this equipment
• Do not posion the equipment too close to the pool
• Do not use any petroleum-based lubricants.
Petroleum aacks the product’s plasc components
• This equipment is not intended for use by anyone
(including children) with restricted physical, sensory
or mental ability, or with limited experience and /
or limited knowledge, unless they are supervised by
someone responsible for their safety, or they receive
instrucon from them regarding the use of the
equipment
• Children must be supervised to ensure they do not
play with the equipment
General Informaon
Condions for the Installaon of a Solar Heater
The Sun2Solar® Deluxe Solar Heater you have purchased is
intended for use with inground and above-ground pools. And
is easy to install and handle. The installaon instrucons are
based on the following condions:
1) You have a pool which is fully built and lled with water
2) Your pool has a lter system
3) You have the required connector hoses to supply the
pool and lter system with water (1 ¼” – 1 ½”)
Once the equipment is installed, it is connected between
your lter system and your pool using the two hose
connectors. (Fig 1) The connector hose forces the cold water
from your lter unit into the solar chambers of your solar
heater. Here it is heated by the sun’s energy and then fed on
to the second connector hose towards the pool.
A = Feed from the lter unit to the solar collector
B = Feed from the solar collector to the swimming pool inlet
nozzles
Water heang depends on the following factors: Flow rate
and level of exposure to the sun
Solar heang only funcons eciently in sunshine. It can
remain connected to the pump in poor weather as this only
causes a slight loss of pressure in the pump.
Tools and Accessories Required
These tools are required for assembly, but are not included in
your set:
• Phillips screwdriver
• Flat head screwdriver
The Ideal Locaon for Your
Sun2Solar® Deluxe Solar Heater
Your solar heater needs to be in a locaon with as much
sunlight as possible
• Never posion the solar heater over the surface of
your pool
• Keep it an adequate distance away from your pool
(keep a safe distance)
• The solar heater is designed to allow maximum
possible penetraon of sunlight
Product Care
The solar heater should not be exposed to cold weather. The
solar heater should be stored in an area protected from frost
before the rst frost, or at the end of the pool season.
All parts must be rinsed or cleaned with water only.
Detergents may damage the protecve cover
Wintering
Drain all the water from the solar collector be closing o
the pipes. Store the equipment away for winter in an area
protected from frost. Remove the pool return pipes.
Make sure there is no water le inside the equipment as this
can freeze. Water expands as it freezes and so can damage
the solar chambers.
Technical Data
Sun2Solar® Deluxe Dome
Above Ground Pool Heater:
• Dimensions: L x W x H – 55” x 55” x 27”
• Maximum Pressure 1 Bar at 68° F
• Water ow rate max 7,500 l/h
• Water content collector 10 I
Sun2Solar® Deluxe Dome
Inground Ground Pool Heater:
• Dimensions: L x W x H – 78” x 78” x 42”
• Maximum pressure 2 bar at 65° F
• Water ow rate max 10,000 l/h
• Water content collector 10 I