1) Remove the water dispenser from the cardboard
box without turning it upside down, or laying it
on its side.
a. Remove the strapping.
b. Lift box from base.
c . Remove the styrofoam packing inserts from the box .
d. Pull the water dispenser straight up from
sytrofoam base.
e. Remove the plastic bag.
The refrigeration compressor has very sensitive
mounts inside of its welded shell in order to
provide quiet running. Improper handling may
damage the compressor.
2) Wipe it clean if necessary.
3) Find a location for your water dispenser that is
protected from direct sunlight and other sources
of heat. Place the water dispenser on a level
surface. Make sure that there are at least
4”/10cm of space between the back of
your water dispenser and the wall. Keep a
minimum distance of 2”/5cm on each side
of your water dispenser free.
4) Do not plug your water dispenser into the power
outlet yet! Read the instructions first.
- 3 -
No. 0101
UNPACKING YOUR WATER DISPENSER
GETTING TO KNOW YOUR WATER DISPENSER
This water dispenser has two thermostats; one for the cooling compartment and one for the cold water (rear panel).
For the cold water, there is a 304 stainless steel water cooling tank.
All waterways are made from 304 stainless steel.
Refrigeration compressor is quiet and durable.
For the hot water there is a 304 stainless steel heavy duty hot water tank with an external heater. It is suitable for
mineral water.
The power cord has a grounded plug. Please make sure that your outlet is properly grounded.
Easy to clean drain tray in the bottom of the cooling compartment.
Integrated No-Spill Receptacle System for added hygiene and convenience.
Three power switches on the rear of the water dispenser. One is for the hot water, the second is for the cooling
compartment, and the third is for the cold water and cooling compartment.
The front panel has three indicator lights, to see if the power, heating and refrigeration are on.
There are three taps on the front. The tap handles are color-coded. Red is for hot, white for room temperature and
blue for cooled water.
The hot water tap handle has a child resistant hot water guard. To operate it, squeeze the handle and locking
device together and then push them down.
Easy to clean deep drip tray.
Convenient built-in fast cooling compartment.
4 in.
min
ongratulations, you have acquired a high quality SUNBEAM
®
Water Dispenser for bottled water. This unit is packed with
many extra features, that you will find convenient to use. Multi-temperature capability allows you to enjoy a cool, hot
or room temperature drink. It will provide you with many years of trouble free use, by following the simple instructions
contained in this manual. Please take the time to read it carefully.
C
This water dispenser is for indoor use only.
Room temperature should not exceed 97°F / 36°C.
To Next Page
Loading...
