-4-
BEFORE FIRST USE
• When using the iron for the first time, test it on a piece of old cloth to be sure
that the Soleplate and the Water reservoir are clean.
• It is possible that the iron will discharge some smoke or give off a slight odor
during it is first usage. This is due to the initial heating of the materials used.
This is completely normal and will stop shortly afterwards.
• When not ironing, always have the Steam Select Switch turned to the close
position .
•
INSTRUCTIONS FOR USE
CHOOSING THE RIGHT WATER
• This steam iron may be used with normal tap water. However, if the water
in the region in which you live is especially hard, it is recommended to use
distilled water to prolong the life of your iron.
• Do not use water that has been desalinated with chemicals.
INSTRUCTIONS FOR USE
1. Turn off the iron and disconnect the plug from
the electrical wall outlet before filling the Iron
with water.
2. Turn the Steam Select Switch to the closed
position .
3. Set the Iron in the position indicated (Figure 2)
and fill it with water, no higher than the Max fill
level shown on the See-Through Water Window.
(Figure 2)
To Next Page
Loading...
