Sunbeam 32610075 - Shot of Steam; Vertical Shot of Steam

-6-
SHOT OF STEAM
®
The Shot of Steam
®
feature provides an extra burst of steam for deep
penetration of stubborn wrinkles. The Shot of Steam
®
feature can be used
with dry or steam ironing provided it has at least a ¼ tank of water and
the Temperature Control Dial is set within the steam band.
1. Allow the iron to heat for approximately 2 minutes.
2. Press the Shot of Steam
®
Button several times to prime the pump.
3. Press the Shot of Steam
®
Button another 3-4 times in order to clean
the unit.
4. The Shot of Steam
®
feature is now ready for use. The Shot of Steam
®
feature can be used continuously with just a short pause between
shots. The Shot of Steam
®
feature is most effective with the Iron held
in a horizontal position on the fabric being ironed.
5. If the Water Reservoir runs dry, unplug the iron and refill with water.
The iron may be filled with water while it is hot. Note: It may be
necessary to re-prime the pump before using the Shot of Steam
®
feature again.
VERTICAL SHOT OF STEAM
®
The vertical Shot of Steam
®
feature allows your iron to function as a garment steamer.
Tip: When using the vertical Shot of Steam
®
on clothing, hang the clothing
on clothes hanger for best results. Hanging curtains and drapes may also be
steamed.
HOW TO USE VERTICAL STEAM
1. Allow iron to warm up.
2. Hold the iron in a vertical position, with the iron close to but not
touching the fabric you want to steam.
3. With your other hand, pull the fabric tight.
4. Press the Shot of Steam
®
button in approximately 3-second intervals
as you move the iron across the wrinkled area.