Sunbeam 7621 User Manual

‘Description
of Display Marks
Display mark
w
Measurement in
progress
T ,.
,\p
Exhaust
insufficient
pressure
Replace batteries
E r r
Measurement error
PUL
Err
Pulse error
Exhaust speed
flashing (exhaust
speed error)
.’
Condition/Cause
OMark appears in the
measurement
condi-
tion and flashes when
pulse is detected.
OMark flashes when
paver is applied and
there is air remaining
in
the cuff.
OMark flashes at the
completion of the
measurement until ex-
haust is complete
0 Measurement was be-
gun but pressure was
insufficient
OAppears when the bat-
tery voltage is ex-
cessively low
0 Appears
w h e n
the
blood pressure could
not be measured ac-
curately.
Appears when
the
pulse could not
ac-
curately be measured.
0 Flashing when exhaust
speed is above 8 mm
Hgls.
I
i
I
j Corrective action
Measurement in progress
-remain quiet.
Press the exhaust button
lo exhaust the air.
Increase pressurization
level by 30 to 40mmHg
and measure once again.
Replace all four batteries
with new ones
First exhaust air from the
Cuff reapply the cuff pro-
perly and remeasure.
Adjust exhaust speed to 2
.o 5mmHg/s.

Sunbeam 7621 Specifications

General

Brand	Sunbeam
Model	7621
Category	Blood Pressure Monitor
Language	English