Care & Maintenance
perform the following maintenance activities on a regular basis:
Keep exterior surfaces clean.
or corrosive cleaning agents.
2. While cleaning your unit, be sure to keep the area around
the burner dry at all times. Do not submerge the control valve
assembly. If the gas control is submerged in water, do NOT use
it. It must be replaced.
• Keep the ventilation opening of the cylinder enclosure free and clear from debris.
blockage include:
• Fire pit does NOT reach the desired temperature.
• Fire pit glow is excessively uneven.
• Fire pit makes popping noises.
use. Clean burner holes by using a heavy-duty pipe cleaner. Compressed air may help clear away smaller particles.
Note: In a salt-air environment (such as near an ocean), corrosion occurs more quickly than normal. Frequently check for
corroded areas and repair them promptly.
Storage
Between uses:
• Turn Control Knob OFF.
• Disconnect LP source.
, dust and
debris).
Note: Wait until fire pit is cool before covering.
During periods of extended inactivity or when transporting:
• Turn Control Knob OFF.
• Disconnect LP source and move to a secure, well-ventilated location outdoors.
, dust and
debris).
• Never leave LP cylinder exposed to direct sunlight or excessive heat.
Note: Wait until fire pit is cool before covering.
Service
Troubleshooting
WARNING
FOR YOUR SAFETY
minutes after use. Fire pit is hot to the touch.
and protective cover.
1-877-387-3639 | Page 14
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
Burner won’t light Propane cylinder is empty Replace propane cylinder
Clear blockage
Control knob is not in ON position Turn control knob to ON
Gas pressure is low
Outdoor temperature is less than 40°F Use a full cylinder
Control knob is fully on
Carbon build-up Clean burner
Thick black smoke Blockage in burner Remove blockage and clean burner inside & outside
To Next Page
Loading...