Sunbeam Contempo Fire Table - Natural Gas Conversion: Disassembly; Disconnecting Propane Components; Removing Propane Orifice

1. Pull out the knob from control panel.
knob
control panel
nut
gas valve
thermocouple
nut
gas valve
2. Unscrew and disconnect the nut from gas valve
counterclockwise using the wrench.
3. Place the re pit face down on a non-abrasive at
surface to prevent scratching, unscrew and disconnect
the thermocouple nut from gas valve counterclockwise
using the wrench carefully and gently.
NOTE: The thermocouple is made of copper,
DO NOT over bend to prevent dysfunctionality
during the disassembly.
2
1
3
CAUTION
Natural gas conversion must be performed only by a
natural gas provider or service company.
Natural Gas
Conversion
Page 8
Hardware Used
Wrench
Hardware Used
Wrench