10
Using Your Pedestal Fan (continued)
Oscillation
Press the oscillation button to choose from
three options of wind direction:
horizontal direction
vertical direction
wave or figure 8 direction
To turn oscillation off, press the oscillation
button again.
Timer
Pre-set to turn on
To pre-set the timer to turn the fan on, place
the fan in “standby” mode (on at the power
outlet but off on the fan) press the preset/timer
button and select the required time (in half
hour increments up to 2 hours, then hourly up
to 10 hours). When the preset time is reached,
the fan will switch ON automatically.
Note: The time must be set when the preset
indicator blinks 3 times. The selected time is
set once the blinking has ceased.
Pre-set to turn off
To pre-set the time to turn the fan off, press
the preset/timer button to switch to timer
mode. Press the timer button once to set the
desired time for the fan to cease operating.
When this set time is reached, the fan will
switch OFF automatically. The timing intervals
are the same as to turn the fan on. Press timer
button again to switch back to preset mode.
Note: You may also pre-set your fan to turn off
whilst in stand by mode.
To Next Page
Loading...
