Sunbeam MultiProcessor LC6950 - Fitting;using the tools on your MultiProcessor; Tool Installation and Usage

12
Heading
Note: Allattachmentsmustbefirmly
attachedtothespindle.Alwaysadjustthe
attachmentsuntilyouaresurethattheyare
correctlyfitted.
Placing the spindle
1.Fitthespindleontothedriveshaft,see
Figure6.
Processing Blade
1.Fittheprocessorbowlandspindleas
detailedpreviouslyinFigures2,3&6.
2.Removetheprotectivecoverfromthe
stainlesssteelprocessingblade,see
Figure7.
3.Fittheprocessingbladeoverthespindle
andpressfirmlyintoplace,seeFigure8.
Warning: Useextremecautionasbladesare
sharp.Alwayshandlethechoppingbladeby
itscentralplasticsection.
4.Placefoodintotheprocessingbowl.
5.Fittheprocessingbowlcovertothe
processingbowl,seeFigures4&5and
placethefoodpusherinthefeedtube.
6.Plugthepowercordintoa230-240VAC
poweroutletandturnthepower‘ON’.
7.Selecttherequiredspeed.
8.Whenprocessingiscomplete,removethe
spindleandbladefromtheprocessingbowl
beforeremovingtheprocessedfood.
Note: Aftercleaning,alwaysreplacethe
protectivecoveronthestainlesssteel
processingblade.
Dough Blade
1.Fittheprocessorbowlandspindleas
detailedpreviously,inFigures2,3&6.
2.Fitthedoughbladeoverthespindleand
pressfirmlyintoplace,seeFigure9.
3.Placeingredientsintotheprocessingbowl.
4.Fittheprocessingbowlcovertothe
processingbowl,seeFigures4&5and
placethefoodpusherinthefeedtube.
5.Plugthepowercordintoa230-240VAC
poweroutletandturnthepower‘ON’.
6.Selectrequiredspeed.
7.Whenprocessingiscomplete,removethe
spindleandbladefromtheprocessingbowl
beforeremovingthedough.
Fitting/using the tools on your
MultiProcessor
spindle
chopping
blade
LC6250
Pictured
Fig 8
spindle
dough
blade
Fig 9
LC6250
Pictured
spindle
drive
shaft
LC6250
Pictured
Fig 6
Fig 7