Sunbeam MultiProcessor LC6950 - Page 17

17
7.Blade5isthe‘FineShredding’blade
anditspositioninthebladestorage
compartmentisthefarrightfrontposition,
seeFigure28.
8.Blade6isthe‘CoarseShredding’blade
andispositioneddirectlybehindthefine
shreddingblade.
Processing bowl storage,seeFigure29.
1.Placetheprocessingbowlontothebaseof
thefoodprocessor.
2.Fitthespindleoverthedriveshaft.
3.Fitthewhiskattachmentoverthespindle.
4.Taketheprocessingbladewithcoverand
placeoverthespindle.Theprocessing
bladeshouldbesittingwiththeblade
coverrestingontopofthewhisk
attachment.
Warning: Useextremecautionasbladesare
sharp.Alwayshandlethechoppingbladeby
itscentralplasticsection.
5.Fitthedoughbladeoverthespindle.The
doughbladehasanarrowopeningonone
endandalargeropeningontheother.
Placethedoughbladewiththenarrowend
restingonthetopofthechoppingblade.
6.Placethebladeholdingdiscoverthe
spindleandthenfittheprocessingbowl
covertotheprocessingbowl.
Cord storage
Thepowercordcanbestoredbywrappingit
aroundthetwoclipsonthebackofthemotor
base,seeFigure30.
LC6250
Pictured
Storing your Sunbeam MultiProcessor continued
Fig 28
Fig 29
Fig 30