Suncast BMDB134004 - Assembly Steps 9-12 (Parts Box A); Attaching Hinges and Shocks (Box A)

Insert Spacer ( BB) on right side. Attach using one screw ( CC).
Repeat step 5 to opposite side.
At an angle, insert the three hooks on ( D) into ( A). Rotate ( D) upright to lock
the hooks.
5
Slide Lock Hasp Bracket ( I) into channel on lid and push up toward front of ( E)
until flush. Fasten with one screw ( AA).
6
Repeat steps 3 & 5 to connect ( D) to both B's.
7
o
L
Je)e)e)c)r)oeeeoe)e)oc)e)
ot)c)oe)oeeoc)eoeib)oc)e)oc)
0-00000000000 0006000
000000 ?) 000000' ) 000 0
000eeeeic)e)oe)e)oe ,-- )e)e) 6 )e ,
oe)c)c)eeeeoe)c)oec)oec)e)
oec)eoeoeeeeeeeeL)oc)o
0-) -- 7)(si) ,) eeeeeeeeetooeo
ÉDeeeoeeeeee
-- )oeoc , oeof
oeoe
8
Place lid ( E) on flat surface. Place ( F) in channel on ( E). Attach through pre- drilled
holes on each end with two screws ( AA). Attach rest from outside toward center
using six screws ( AA). There are no pre drilled holes on the lid. Use force when
starting to drive self taping screws. Once the screw pierces the plastic, it will drive
easier.
Note: Two holes on each side of center screw will not be used.
Do not use center hole on ( F).
0 x8
7