2. Choose one end of the assembled Floor to be the front of the shed.
Locate one Panel I with two arrows and insert Panel Connector C. Press
down into place.
With the two arrows pointing towards the floor, attach Side Panel Ito
Floor. Press down on part until part snaps into place (3 snaps).
4. Locate one Panel I with one arrow and insert one Hinge Cap G into the
bottom of one Panel I. Press until part snaps in place.
With the one arrow pointing towards the floor, slide Panel I onto panel
posts making sure to insert the panel onto the Panel Connector C. Press
together until parts snap in place (3 snaps).
.
4
3. Insert one Panel Connector C into one Panel B. Press down into place.
Slide Panel B onto Panel I connector post. Press Panel B until part snaps
in place (2 snaps).
Panel I Connector Post.
Front
To Next Page
Loading...