Sunex Tools 8035 User Manual

8035 & 8035R 06/13/11
MODELS 8035 & 8035R
SLIDE TOP UTILITY CART
PARTS LIST
Examine box contents, then proceed with the following instructions.
Drawer
Assembly
Barrel Keys
Locking
Casters (2)
Fixed
Wheels (2)
Push Handle (1)
EVA Liners (4) Rubber Mats (2)
TOOLS
NEEDED
Phillips
Screwdriver
13mm
Wrench
2 People
Legs (4)
Tabletop or
workbench*
Bottom Tray
M8 x 16
(16 pcs.)
M8 x 16
(32 pcs.)
M8 x 20
(4 pcs.)
M8 Nut
(16 pcs.)
M8 Washer
(64 pcs.)
WARNINGS, ASSEMBLY INSTRUCTIONS & PARTS BREAKDOWN
PARTS LIST
WARNING
THIS OPERATING MANUAL CONTAINS IMPORTANT SAFETY INFORMATION.
READ CAREFULLY AND UNDERSTAND ALL INFORMATION BEFORE USING
THIS CART. SAVE THIS MANUAL FOR FUTURE USE.
Units can tip or strike you.
• Maximumloadcapacity450lbs.
• Donotopenmorethanoneloadeddraweratatime.
• Closelidandlockdrawersbeforemoving.
• Donotstepinorondrawers.
• Secureunitstogetherwithfasteners.
• Applybrakesonlockingcasterswhennotmoving.
Tippingofstorageunitorunitstrikingyoucancauseinjuryanddamage.
Componentedgescancutorpinch.
• Weargloveswhenliftingbyedges.
• Keepfeetandfingersclearofedges
 whenstacking,hanging,ormovingunits.
• Movecartslowlywhenloaded,avoid
 cracks,holesandotherfloorirregularities.
• Donotpull;pushtomove.
 Unitedgescancauseinjury.
Particlesmayflyduringassembly.
Wearsafetygoggles,assemblerandbystanders.
Flyingparticlescancauseeyeinjury.
8035_Manual_061311.indd 1 6/15/11 3:54 PM

Sunex Tools 8035 Specifications

General

Brand	Sunex Tools
Model	8035
Category	Outdoor Cart
Language	English

Summary

Safety Warnings and Preparation

General Safety Precautions

Important safety information regarding unit operation, tipping, and component handling to prevent injury.

Parts and Tools Identification

Lists all components and required tools for assembly verification and preparation.

Assembly Instructions

Step 1-4: Initial Assembly

Covers preparation, attaching casters to the bottom tray, aligning legs, and connecting the tray to legs.

Step 5-6: Final Assembly

Details attaching the push handle and completing the cart assembly process.