EasyManua.ls Logo

Sunfire Series II - Standard Edition Specifications

Sunfire Series II
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
User's Manual
© 2001 Sunfire Corporation.
All rights reserved. Sunfire Corporation
reserves the right to improve its products at
any time. Therefore, specifications are subject
to change without notice.
Manual part number : 913-042-00 Rev A
Standard Edition Specifications
Standard Edition Specifications
Power output
325 watts continuous, per channel,
both channels driven into eight ohms,
from 20Hz-20kHz with no more than
0.5% T.H.D.
Power at clipping, minimum:
650 watts per channel into four ohms.
1300 watts per channel into two ohms
(time limited basis).
Hum and Noise
-100 dB, A-Weighted
Maximum output current
80 amperes peak to peak per channel
Maximum output voltage
51 Vrms
Output impedance
Voltage source: Approximately zero ohms
Current source: Approximately one ohm
Input impedance, RCA inputs
30k
Input sensitivity for rated output
Unbalanced: 1.8 Vrms
Balanced: 1.8 Vrms
Input impedance, XLR inputs
24k, each leg balanced to ground
Female XLR
Pin 1 is ground
Pin 2 is negative (cold)
Pin 3 is positive (hot)
Power Consumption
45W At idle
150W Typical (1/8th power)
1800W Absolute Max (Fuse Limit)
Dimensions
19.0 inches wide
6.5 inches high (including feet)
15.75 inches deep
Weight
37 lbs
Finish
Brushed aluminum and black anodize

Related product manuals