4+1+1 system:
Note:
1) Before starting up and running, please check whether the connection was correct to avoid any abnormalities
in the system.
2) All wiring must be fixed and reliable to avoid wire drop during use.
3) When the AC output is wired to the load, it shall be properly wired according to the requirements of the
electrical load equipment to avoid damage to the load equipment.
4) Setting item “output voltage setting”needs to be set consistently or only for the master. When paralleling,
the voltage set by the master will prevail, and the master will be forced to rewrite the rest of the slaves to be
consistent. This option can be set in standby mode only.
To Next Page
Loading...
