Need help?Do you have a question about the SUNFORD ELECTRONICS SF003 and is the answer not in the manual?
Ensure adequate vertical and horizontal distance between antennas and correct orientation to prevent interference.
Choose a location allowing sufficient separation and higher position for better signal reception, minding lightning protection.
Orient antennas to avoid facing each other directly to prevent signal oscillation and interference.
Details on how to attach the inside antenna bracket to a wall using screws and anchors.
Measure signal strength in dBm from both antennas to compare and confirm optimal results.
Solid green lights indicate normal operation and successful self-test for band indicators and power.
Blinking red lights signify reduced gain due to oscillation, a safety feature to prevent interference.
Solid red lights indicate a band has shut off due to oscillation, preventing harmful interference.
Describes the expected behavior of the DC power indicator (solid green for correct functioning, off for issues).
Solutions for blinking red lights, including increasing antenna separation or checking gain reduction.
Addresses solid red lights, suggesting increased antenna separation and power cycle to resolve oscillation.
Fixes for solid orange lights, involving adjusting the outside antenna for strongest signal or changing mount location.
Guidance for when the DC power indicator is off, checking power supply and cord tightness.
Maintain minimum separation distances for inside and outside antennas for compliance and safety.
Adhere to RF safety limits and register the device with your wireless provider before use.
Covers Canadian requirements, E911 accuracy, and operational restrictions for safe and legal use.
General| Brand | SUNFORD ELECTRONICS |
|---|---|
| Model | SF003 |
| Category | Extender |
| Language | English |
To Next Page
