Sungrow Logger1000B User Manual

66
Step 3 Click to save the settings.
- - End
7.10.11.8 DO
An external IO module is required to enable the DO function.
Step 1 Choose “System→Port Parameter→DO”, and enter the corresponding interface.
Step 2 Set the following parameters.
Parameter
Description
Initial Status
The status of the DO port during normal operation.
• NO
• NC
Function
• Communication control: Issue commands via iSolarCloud or a
third-party device.
• Manual control: Control the status of the DO port manually on the
web interface.
Action mode
• Level: The status of the DO port changes, and then stays the same.
• Pulse: The status of the DO port changes and, after staying the
same for a certain period of time, switches to the initial status. The
duration of this period is set in Pulse Duration.
Pulse Duration
Pulse Duration can be set provided that Action mode is set to Pulse.
Range: 1-60s.
Purpose It notes the purposes of the DO port.
Step 3 Click Manual control at the upper right of the page. Set Control mode to Reset or Action,
and click Confirm.
• Reset: The DO port is restored to the initial status.
• Action: The DO port switches to the reverse status of Initial Status.
This step is applicable only when Function is set to Manual control.
If Initial Status is NO, its reverse status is NC.
If Initial Status is NC, its reverse status is NO.
Step 4 Click
to save the settings.
- - End
7 WEB Interface User Manual

Sungrow Logger1000B Specifications

General

Brand	Sungrow
Model	Logger1000B
Category	Data Loggers
Language	English