38
When the aluminum wire is selected, a copper-aluminum adapter terminal is needed as
shown below:
No. Name No. Name
A
Copper bus
D
Disc spring
washer
B
Copper-aluminum adapter
terminal
E Flat washer
C Bolt F Nut
3 Fasten the bolts with screwdriver or spanner.
• Incorrect connection sequence may cause fire. Pay maximum attention to the
connection sequence.
• Ensure the firmness of the cable connection. Poor connection or oxidation of
the surface may cause over-heating or fire.
• Long bolts may affect the insulation and may cause short circuit.
• Remove the heat-shrink tubing between the cable lug and the copper bar if
necessary. Poor contact or over-heating may follow if otherwise.
step 6 Confirm that all cable connections are secure.
- - End
6 Electrical Installation System Manual
To Next Page