Sungrow SG3600UD - Running Parameters; Protection Parameter

63
• Set parameter from the Serial Port Parameter interface for baud.
• Set parameter from the Network Parameter interface for IP address, subnet mask,etc.
- - End
9.13.2 Running Parameters
Setting Running Parameters
step 1 Tap “Function” from the default menu.
step 2 Tap “Set-parameter”.
step 3 Tap “Run-parameter” after entering the correct password.
step 4 Set the running parameter by tapping the pop-up keypad and tap ENTER to confirm setting.
Tap “Prev” or “Next” to turn pages up or down.
- - End
9.13.3 Protection Parameter
Setting Protection Parameter
step 1 Tap “Function” from the default menu.
step 2 Tap “Set-parameter”.
step 3 Tap “Pro-parameter” after entering the correct password.
step 4 Set the protection parameter by tapping the pop-up keypad and tap ENTER to confirm
setting. Tap “Prev” or “Next” to turn pages up or down.
- - End
System Manual 9 LCD Menu Operation